EVAK PUMPS V4P-4023, solo hydraulics

• EVAK V4P series submersible pumps are made of corrosion-resistant and abrasion-resistant steel in combination with high-quality and durable plastic using the latest technology.
• Pump casing, lower and upper housing, motor coupling and shaft made of stainless steel.
• Impellers and diffusers in technopolymer.
• They are manufactured according to the most modern standards to achieve high efficiency, maximum energy savings and a very long service life.
• They are designed for pumping clean water with a temperature of up to 60°C and with a fine floating sand content of up to 50g/m3.

HYDRAULIC PART

• Built-in stainless steel floating flap
• Stainless steel shaft and sliding bushings
• Completely smooth safety handles
• Complies with NEMA 4 standard
• High-quality shaft sleeves with minimal friction
• Impellers made of special technopolymer, highly resistant to wear
• Technopolymer diffusers for performance optimization
• Integrated stainless steel filter protects the pump from sand and other impurities

MOTORS AND CABLES

• The pumps are supplied as complete sets with 4OM (PM Technology) submersible motors.
• The pump can be ordered with standard cable lengths of 10, 20, 30 or 50m. The cables are connected to the motor using removable connectors, making cable replacement very quick and easy and the cables do not contain any additional couplings or extensions.
• It is always possible to supply sets with any non-standard cable lengths (on request).
• Three-phase sets are supplied on request with a cable with a free end; protection must be provided externally.

USE

• Supply of drinking or service water from deep boreholes and wells
• Agricultural and private irrigation
• Domestic, municipal and industrial waterworks
• Fountains and other general water transportation
• General water supply from boreholes and narrow wells.
• For installation in classic dug wells or rainwater tanks, the pump must be equipped with a cooling jacket (on request)